Description
Did you buy an IS flowed system used? Do you have an older system that could use freshened up? Want to get a few new tune-ups? Changing fuel types? Then the IS Freshen Up service is for you. If you have a numbered IS system that is 4 years old or newer then you can take advantage of this service starting at $175 for single stage plates and $300 for for a Dry direct port system. Systems older than 4 years will require our Blueprint & Flow service.
-Direct Port-
What’s included:
We will take your system apart and check everything out. We will take your solenoids apart, make sure everything is working properly, replace the nitrous plungers, check the fuel plungers and filter fittings as needed. Once the system is back together we will flow it to make sure nothing is leaking and get you 3 new tune-ups with the jets and tech sheet in 50hp increments. Additional tune-ups can be purchased at the time of flowing for $65 each.
What’s an additional charge:
Things that aren’t included in a Freshen Up would be new hardlines and fittings if they leak, solenoid coils, replacement solenoids, bent or broke nozzles, replacement distribution blocks, new nitrous lines and rewiring the system if needed.
-Plate Kit-
What’s included:
We will inspect your plate to make sure the holes are clear of debris, the spray bars aren’t leaking, missing epoxy, bent or turned. Pull solenoids apart to inspect, replace nitrous plungers if they need it as well as filter fittings and check the fuel plungers. Check the nitrous/fuel lines make sure they have a good ID then reassemble and flow the kit for tune-ups from the bottom to the top. All jets and tech sheet in 50hp increments will be included.
What’s an additional charge:
Plate replacement, solenoid or coil replacement, nitrous and or fuel lines replacement.
Prices are as Follows:
Single Entry Plate $175
Crossbar Plate $225
Single Stage Dry Direct Port $300
Two Stage Dry Direct Port $425
Single Stage Wet Direct Port $375
***THIS CAN NOT BE PURCHASED ONLINE. THAT’S WHY IT SHOWS OUT OF STOCK. YOU MUST SEND YOUR PLATE OR MANIFOLD IN FOR THIS SERVICE. FILL OUT THE TECH SHEET BELOW AND SHIP WITH SYSTEM***
https://inductionsolutions.com/wp-content/uploads/2020/09/Website-Tech-Sheet-2020r.pdf
