High Current Nitrous Solenoid Driver

Code: 554-111


Out of stock


A High Current Nitrous Solenoid Driver is required by many progressives to hold the load of high amperage solenoids that the box cannot handle itself. In many cases surging or the system occasionally cutting off mid-run are signs of the progressive controller’s internal drivers being overloaded, if you have experienced these issues we always recommend running the solenoids off a driver instead. These drivers have an ultra-low activation/release time of fewer than 16 microseconds to ensure no delays in reaction times. This relay can also be Pulse Width Modulated (PWM) with no minimum duty cycle at frequencies up to 1000hz.


  • 5-20 volt DC Operation
  • Rugged Solid State Circuitry
  • Easy 3-Wire Connection
  • Included Terminated Pigtail
  • Ultra-fast activation <16 microseconds
  • Pulse Width Modulation (PWM) Compatible
  • PWM 0-100%
  • Up to 1000hz frequency
  • Vibration Resistant
  • Maximum Continuous Current = 40amps
  • Maximum Switching Current = 20amps

Additional information

Weight 1 lbs
Dimensions 6 × 6 × 6 in