Single Stage Dry Direct Port System
Our dry direct port systems include welding CNC bungs into your manifold, blending the bungs into your ports, our annular small body nozzles, .120 bottom exit nitrous solenoids, filtered inlet fittings, with soldered and heat shrunk wiring, as well as, a y fitting and nitrous lines ready to hook up and run. We flow each and every system done in house and custom jet map every one with five tune-ups in 50HP increments and all necessary stainless steel jets for the tune-ups. That is $160 worth of jets included in the system!! System also comes with a free Induction Solutions t-shirt. We can work with you to meet any hood clearances, class regulations, etc. All direct port systems are custom to your application and can flow anywhere from 100-500 horsepower! We can also do upgraded systems to support more horsepower for those who need more than 500HP! At time of direct port purchase a flow tool can be bought for $50 off, and any additional t-shirts are half price. To give us the appropriate information please download and fill out one of our tech sheets and ship it along with your manifold to the shop address in the contact us section of the site.
NOTE: We charge $50 for each additional dry tune up over the provided 5
NOTICE: DO NOT send carburetors or regulators, and all tunnel ram intakes must have linkage sent with them.
EFI Systems must supply us with the throttle body and fuel rails.
Link to Tech Sheet: https://inductionsolutions.com/tech-sheet/
If you have an Induction Solutions flowed system please call Steve for help with your timing, if not please utilize this general timing sheet as a guideline