Direct Port Water Injection Plumb Kit
Water injection is becoming increasingly popular in today’s race cars, by injecting a fine mist of water into your engine it drastically reduces the chance of detonation occurring during a run. The water, while in a gaseous state, can absorb enormous amounts of heat and also raises the effective octane of the fuel, both aiding in the engines overall performance and safety. Our kit is the closest thing to a plug and play system on the market!
Our kit includes:
- Water Tank
- High Pressure Pump (only draws 10 amps at 200PSI)
- Relay Harness
- Wiring and Electrical Pieces
- 6ft of Heat Shrink
- 1/4 Water Feed Line
- Check Valve
- 1/4 to 5/32 Y
- 4ft of 5/32 Water Line
- All Plumbing Pieces Pictured
- 8 Individually Jetable Nozzles
**NOTE** You will need to have water injection bungs welded into your intake in order to install this product!!
As with any water injection system, it is important to periodically clean the filters to prevent blockage.
The filter can be cleaned by simply removing the screen off the nozzle then soaking it in some lime away for about 15-30 min. Make sure to rinse the nozzle to remove the chemicals.